What is the maximum size of tempered glass available from a Chinese manufacturer?
Most Chinese tempering lines stop at 2,440 × 5,100 mm. Jumbo lines reach 3,300 × 12,000 mm, and the largest architectural panels currently produced in China are 3,660 × 12,000 mm — 43.9 m² from a single sheet.
Glass size is limited by the furnace, not by the glass. A float line can produce a 3,660 mm wide ribbon, but a tempering furnace must heat the sheet evenly and quench both faces at the same rate, so its ceramic roller bed sets the practical ceiling.
In China the three common furnace classes are 2,440 × 5,100 mm (standard), 3,300 × 9,000 mm (large), and 3,660 × 12,000 mm (jumbo). The 3,660 × 12,000 mm class is the one that matters for full-height facades, because a 12 m panel removes a horizontal joint on a typical four-storey module.
Key figures
| Maximum jumbo panel | 3,660 × 12,000 mm (43.9 m²) |
|---|---|
| Maximum standard panel | 2,440 × 5,100 mm |
| Thickness range | 4–19 mm |
| Weight of one jumbo panel at 12 mm | about 1,310 kg |
Practical notes
- Above 6 m length, panels must be transported on a stillage in a 40 ft open-top or flat-rack container; 12 m panels are shipped by break bulk or specially built racks.
- Jumbo panels are usually heat-soak tested, because the residual stress in a 43.9 m² sheet is far higher than in a standard panel.
- Practical limit for coated Low-E jumbo: off-line coated glass is normally capped at 3,210 × 6,000 mm by the coating line, so check coating before promising 12 m.
Send the glass schedule, thickness build-up and destination port to info@cnglassworks.com or on WhatsApp (reply within 1 hour) / phone +86 138 3303 3053. A specification review and reference price come back within one working day.
Figures verified by the factory on 2026-11-02. Sizes are manufacturing limits, not project guarantees.